Editor Settings

General Settings

Snap distance

The snap distance as defined in the Snap-Distance toolbar is used for all regionalization options applying values to a target geometry. It defines the distance up to which targets will be considered. The setting here provides the default shown in the Snap-Distance toolbar when the model is loaded.

Minimal Slice Distance

When applying elevation data to the model, the resulting mesh geometry is validated, using this minimal slice distance. If the resulting slice distance is below the set minimum, the Verify Assignment dialog is brought up, allowing for different ways of correction.

 

The elevations are not automatically validated again when changing this setting. To validate current elevations for the new minimal slice distance, use the Validate button in the 3D-Layer Configuration dialog.

Raster Settings

In this part, the distances for a raster can be defined in X and Y direction. The raster can for example be used in 2D Supermesh design.

Table of Contents

Index

Glossary

-Search-

Back